STS RWD V8-4.6L (2007)
8. Remove the brake hose to caliper bolt (4) from the brake caliper (1).
9. Remove the brake hose (2) from the vehicle.
10. Place a shop towel on a hard surface.
11. Tap the threaded end of the brake hose to caliper bolt (4) on the shop towel to remove the gasket (3) from the bolt.
12. Remove and discard the 2 copper brake hose gaskets (3). These gaskets may be stuck to the brake caliper (1) and/or the brake hose end (2).
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
13. Install a rubber plug into the brake hose to caliper bolt hole of the brake caliper.
Installation Procedure
1. Remove the rubber plug from the brake hose to caliper bolt hole of the brake caliper.
Important: Install NEW copper brake hose gaskets.
2. Assemble the brake hose, the NEW copper brake hose gaskets (3) and the brake hose bolt (4) to the brake hose (2).
Notice: Refer to Fastener Notice.
3. Install the brake hose to caliper bolt (4) to the brake caliper (1).
Tighten the brake hose to caliper bolt to 50 N.m (37 lb ft).
