STS RWD V8-4.6L (2007)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the fuel tank pressure sensor electrical connector (1).
Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held
into the canister by the tight fit of the multi-lip seal.
3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.
Installation Procedure
