STS RWD V8-4.6L (2007)
8. Remove the alignment pin.
9. Install a NEW camshaft position actuator solenoid plug.
10. Repeat steps 4 through 9 for the exhaust camshaft position actuator solenoid.
6. Install the left camshaft cover.
7. Install the left intake camshaft sensor.
8. Install the left exhaust camshaft sensor.
9. Install the drive belt tensioner.
10. Install the power steering reservoir.
11. Install the fuel injector sight shield.
Camshaft Position Actuator Housing Replacement - Right Side
Camshaft Position Actuator Housing Replacement - Right Side
Removal Procedure
1. Remove the fuel injector sight shield.
2. Remove the right exhaust camshaft sensor.
3. Remove the right intake camshaft sensor.
4. Remove the right camshaft cover.
5. Remove the cam sensor harness from the retainers.