STS RWD V8-4.6L (2007)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
Crankshaft Position Sensor Replacement
Removal Procedure
1. Remove the intake manifold.
2. Disconnect the crankshaft position sensor electrical connector.
3. Remove the crankshaft sensor retaining bolt.
4. Remove the crankshaft sensor.
Installation Procedure
Important: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
1. Lubricate the crankshaft sensor O-ring with clean engine oil.
Notice: Refer to Fastener Notice.
2. Install the crankshaft sensor and the retaining bolt.
Tighten the retaining bolt to 10 N.m (89 lb in).
3. Connect the crankshaft position sensor electrical connector.
4. Install the intake manifold.
5. Perform the Crankshaft Position System Variation Learn. See:
