STS RWD V8-4.6L (2007)
7. Install the seat back panel (2) to the seat (1) by sliding the bottom of the panel into place and pushing the top of the panel in until the push-in
retainers are secure.
8. Enable the SIR system. Refer to SIR Disabling and Enabling.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
Inflatable Restraint Side Impact Module Wiring Harness Replacement
Inflatable Restraint Side Impact Module Wiring Harness Replacement
Removal Procedure
Caution: Refer to SIR Inflator Module Handling and Storage Caution.
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Partially remove the seat back panel to access the wiring.
Important: Removal of the right or the left inflatable restraint side impact module wiring harness uses the same procedure.
3. Remove the inflatable restraint side impact module (2) from the seat (1).
With the seat back panel removed, the inflatable restraint side impact module wiring harness (3) will be exposed.
4. Remove the retaining clips that fasten the side impact module wiring harness (3) to the seat (1).
Installation Procedure
1. Install the new side impact module wiring harness (3) to the seat (1).
2. Install the retaining clips that fasten the side impact module wiring harness (3) to the seat (1).
3. Install the side impact module (2) to the seat (1). Refer to Inflatable Restraint Side Impact Module Replacement - Front.
4. Install the seat back panel.
5. Enable the SIR system. Refer to SIR Disabling and Enabling.
Inflatable Restraint Steering Wheel Module Replacement
Inflatable Restraint Steering Wheel Module Replacement