STS RWD V8-4.6L (2007)
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: DO NOT use washers, spring washers, or toothed washers when installing the knock sensor. Tighten the bolt to the proper
torque.
2. Install the KS (1) and bolt.
Tighten bolt to 20 N.m (15 lb ft).
Important: The KS wiring harness is held in place with several retaining clips.
3. Ensure that the wiring harness is installed correctly.
4. Connect the KS electrical connector (2).
5. Install the intake manifold.
