STS RWD V8-4.6L (2007)
4. Tighten the power steering gear retaining bolts.
Tighten the bolts to 120 N.m (89 lb ft).
Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools
are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.
5. Install the lower control arm ball joint nut (1).
1. Tighten the nut to 20 N.m (15 lb ft).
2. Tighten the nut to an additional 180 degrees.
