STS RWD V8-4.6L (2007)
Seals and Gaskets: Service and Repair
6L50/6L80/6L90 - Automatic Transmission
Extension Housing and Seal Replacement (6L50)
Extension Housing and Seal Replacement (6L50)
Tools Required
J 45012 Holding Fixture
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the exhaust system.
3. Remove the drive shaft.
4. Support the transmission with a suitable jack.
5. Remove the transmission mount assembly.
6. Install the propeller shaft flange holding fixture J 45012.
Notice: Do not reuse the flange nut. Reusing the flange nut may cause damage to the transmission.
7. Remove and discard the propeller shaft flange nut.
8. Remove the propeller shaft flange.