STS RWD V8-4.6L (2007)
10. Install the J 45012 to the drive pinion flange.
Notice: Refer to Fastener Notice.
11. While holding the J 45012 tighten the drive pinion nut.
Tighten the pinion flange nut to 241 N.m (178 lb ft).
12. Remove the J 45012 from the pinion flange.
13. Install the propeller shaft to the drive pinion flange.
14. Install the propeller shaft to the drive pinion flange bolts.
Tighten the (6) propeller shaft coupler-to-differential flange bolts in sequence (1-6) to 30 N.m (22 lb ft).
15. Inspect the fluid level. Refer to Front Axle Lubricant Level Inspection.
