STS RWD V8-4.6L (2007)
6. Clean the tape residue from the windshield.
Windshield Reveal Molding Replacement
Windshield Reveal Molding Replacement
The windshield reveal molding is an applied molding design separate from the window. The reveal molding is bonded to the windshield and may be
bonded to the body. The reveal molding may be replaced with the windshield as an assembly, or the reveal molding may be available as a separate
service part. Refer to Urethane Adhesive Installation of Stationary Windows.
Windshield Side Reveal Molding and Windshield Reveal Molding Clip Replacement
Windshield Side Reveal Molding and Windshield Reveal Molding Clip Replacement
Removal Procedure
Important: If the retainer clips become damaged, new retainer clips are required.
1. Do Not bend in order to reform the retainer clips.
2. Remove the windshield side reveal molding from the vehicle.
Important: Apply 2 layers of masking tape on the glass next to the retainer clip (1) being replaced.
3. Apply the protective tape.
Caution: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
4. Drill the rivets (2) securing the retainer clip to the windshield pillar.
5. Remove the retainer clip (2) from the windshield pillar flange.
6. Ensure all the metal shavings are removed from the windshield pillar area prior to the reveal molding installation.
Installation Procedure
1. Position the new rubber spacer to the inside of the vehicle.
The arrow on the rubber spacer must point outward upon installation.
