STS RWD V8-4.6L VIN A (2006)
Garage Door Opener Transmitter: Service and Repair
Garage Door Opener Replacement
GARAGE DOOR OPENER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the overhead console.
2. Remove the screws (1) securing the garage door opener to the overhead console.
3. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Locate the garage door opener to the overhead console.
2. Install the screws (1) securing the garage door opener the overhead console.
Tighten the screws (1) to 2 N.m (18 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector.
4. Install the overhead console.
5. Refer to Control Module References for programming and setup information. See: Testing and Inspection/Programming and Relearning