cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Procedures|Page 21234 > < Procedures|Page 21232
Page 6
background image

21. Disconnect the connector lead (3) for the antenna module from the rear window (1).
22. Pull down at the attachments in order to detach the 6 glue bond spots on the cardboard roof insulator to headliner.

NOTE:  Use care when removing or installing the headliner. Excessive bending will damage the headliner.

23. Using J 38778, disconnect the yellow plastic retainer (1) securing the headliner to the roof panel above the overhead console.
24. With the aid from an assistant, remove the headliner through the right front door.

IMPORTANT:  When removing the headliner out the right front door, be careful not to damage the right front door upper rear weatherstrip seal.

25. Place the headliner upside down on a clean protected surface.

26. Disconnect the electrical connector (1) from the antenna module.
27. Disconnect the 2 coaxial cables (3, 4).
28. Remove the antenna module from the bracket on the headliner.

IMPORTANT:  Prior to removal, note the location of the ground strap for installation.

INSTALLATION PROCEDURE

1. Position the new headliner upside down, on a clean protected surface.

2. Transfer the antenna module (2) to the new headliner.
3. Attach the antenna module (2) to the bracket.
4. Connect the electrical connector (1).
5. Connect the 2 coaxial cables (3, 4).
6. Ensure the antenna module ground strap is positioned properly to the headliner.

Procedures|Page 21234 > < Procedures|Page 21232