STS RWD V8-4.6L VIN A (2006)
2. Route the outboard shoulder belt and escutheon through the sail panel.
Important: Ensure the shoulder belt is free of twists.
3. Straighten the belt, if needed, prior to securing the shoulder belt floorpan fastener.
4. Position the upper sail panel downward next to the end of the rear shelf trim panel.
5. Insert the upper metal integral clip (1) on the trim panel to the slot located in the headliner.
6. Insert the lower metal integral clip (2) to the sheet metal.
7. Position the plastic push-in retainer (3) to the hole in the sheet metal.
8. Press inward at the plastic retainer in order to secure.
Notice: Refer to Fastener Notice in Cautions and Notices.
9. Install the fastener with a magnetic-tipped screwdriver.
Tighten the screw to 2 N.m (18 lb in).
10. Secure the seat belt escutheon to the sail panel.
11. Install the screw cover to the sail panel.
12. Enable the SRI system. Refer to SIR Disabling and Enabling Zones .
Shelf Carrier Replacement - Rear
Shelf Carrier Replacement - Rear
Removal Procedure
1. Remove rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf (See: ) .
2. Remove the 7 fasteners securing the carrier assembly to the rear shelf.
3. Disconnect the electrical connectors.
4. Remove the rear shelf carrier assembly.
Installation Procedure
1. Install rear shelf carrier assembly.
