STS RWD V8-4.6L VIN A (2006)
4. Notice: Refer to Fastener Notice.
Install the camshaft cover bolts installing the ground strap to the camshaft cover.
^
Tighten the camshaft cover bolts to 10 Nm (89 inch lbs.).
5. Install the ignition module.
6. Connect the cable harness clips to the front of the camshaft cover.
7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
8. Install the bolts securing the wire harness bracket to the cylinder head.
^
Tighten the wire harness bracket bolts to 45 Nm (33 ft. lbs.).
9. Install the front air deflector.
10. Lower the vehicle.