STS RWD V8-4.6L VIN A (2006)
1. Align the timing marks (1) of the camshaft intermediate and crankshaft sprockets. The marks should be aligned vertically in the installed position.
2. Install the primary camshaft drive chain on the drive sprockets.
3. Use the J 39946 to rotate the crankshaft until the crankshaft keyway is approximately at the 1 o'clock position.
4. Install the following as an assembly:
^
The primary camshaft drive chain (3)
^
The crankshaft sprocket
^
The camshaft intermediate sprocket
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the camshaft intermediate sprocket retaining bolt.
^
Tighten the camshaft intermediate sprocket retaining bolt to 60 Nm (44 ft. lbs.).
