STS RWD V8-4.6L VIN A (2006)
9. Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
Carefully remove the wheel bearing/hub retaining bolts.
10. Install J 45859 or equivalent to the vehicle.
11. Using J 45859 or equivalent carefully separate the wheel driveshaft from the wheel bearing/hub.
12. Remove the wheel bearing/hub from the vehicle.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
