STS RWD V8-4.6L VIN A (2006)
8. Install J45859 or equivalent to the wheel bearing/hub.
9. Using J45859 or equivalent carefully disengage the wheel driveshaft from the wheel bearing/hub.
10. Remove the wheel bearing/hub.
Installation Procedure
1. Install the wheel bearing/hub.
2. Install the wheel bearing/hub mounting bolts.
Tighten the wheel bearing/hub mounting bolts to 135 Nm (100 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
