STS RWD V8-4.6L VIN A (2006)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Remove the oil filter adapter.
2. Remove the oil pressure sensor and/or switch from the oil filter adapter.
3. Clean and inspect the oil filter adapter. Refer to Oil Filter Adapter Cleaning and Inspection (Without Oil Cooler) Oil Filter Adapter Cleaning and
Inspection (With Oil Cooler) .
Installation Procedure
1. Install a new O-ring on the oil pressure switch.
2. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
Install the oil pressure switch to the oil filter adapter.
^
Tighten the oil pressure sensor and/or switch to 16 Nm (12 ft. lbs.).