STS RWD V8-4.6L VIN A (2006)
50. Disconnect the I/P module yellow harness connector (1) from the vehicle harness connector (2).
51. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
IMPORTANT: If vehicle is equipped with dual stage air bags the I/P module will each have 4 wires. Refer to SIR Connector End Views for
determining high and low circuits.
52. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
53. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
54. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
55. Twist together one end from each of the wires in order to short the wires.
56. Twist together 2 connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
SIR Connector End Views in order to determine the correct circuits.
57. Inspect that the 3-wire connection is secure.
