STS RWD V8-4.6L VIN A (2006)
2. Position the sensor horizontally on the mounting surface.
3. Point the arrow on the sensor toward the front of the vehicle.
4. Install the mounting fasteners.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the fastener to 9 N.m (80 lb in).
5. Connect the harness wiring connector to the front end sensor.
6. Install the CPA to the wiring harness connector on the front end sensor.
7. Reposition the radiator.
8. Install the radiator sight shield.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.