STS RWD V8-4.6L VIN A (2006)
1. Position the battery positive cable to the engine.
2. Install the positive battery cable to the retaining features on the engine wiring harness bracket.
3. Connect the battery positive cable (2) to the starter and install the starter terminal nut.
NOTE: Refer to Fastener Notice.
Tighten the nut to 10 N.m (89 lb in).
4. Install the intake manifold.
5. Connect the cable retaining clip to the stud.
6. Install battery positive cable (2) and nut (1) to the underhood fuse block.
Tighten the nut to 15 N.m (11 lb ft).
7. Install the underhood fuse block cover to the underhood fuse block.
8. Install the wiring harness to the retaining features on the underhood fuse block cover.
