STS RWD V8-4.6L VIN A (2006)
Alternator: Service and Repair
Generator Bracket Replacement
GENERATOR BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the battery negative cable.
2. Remove the generator.
3. Remove the generator drive belt tensioner.
4. Remove the right side engine mount bracket.
5. Remove the generator bracket bolts (1, 2 and 3).
6. Remove the generator bracket from the engine.
INSTALLATION PROCEDURE
1. Install the generator bracket to the engine.
2. Install the generator bracket bolts.
NOTE: Refer to Fastener Notice.
Tighten the generator bracket bolts in the sequence shown to 50 N.m (37 lb ft).
3. Install the right side engine mount bracket.
4. Install the generator drive belt tensioner.
5. Install the generator.
6. Connect the battery negative cable.
