STS RWD V8-4.6L VIN A (2006)
9. Remove the fasteners (1, 2) securing the electrical center (3) to vehicle.
INSTALLATION PROCEDURE
1. Install fasteners (1, 2) securing the electrical center (3) to vehicle.
NOTE: Refer to Fastener Notice.
Tighten the fasteners to 10 N.m (86 lb in).
2. Install the harness at the locking tabs (1).
3. Install the fasteners (3) securing the electrical center board (2).
Tighten the fasteners to 7 N.m (62 lb in).
4. Install the fastener securing the negative cable (2) to the electrical center.
Tighten the fasteners to 15 N.m (11 lb ft).
