STS RWD V8-4.6L VIN A (2006)
Starter Motor: Service and Repair
STARTER MOTOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the battery negative cable.
2. Remove the intake manifold.
3. Disconnect the battery positive cable (2) from the starter.
4. Disconnect the wire (4) from the S terminal on the starter.
5. Remove the starter motor bolts.
6. Remove the starter motor.
INSTALLATION PROCEDURE
1. Install the starter motor.
2. Install the starter motor bolts.
NOTE: Refer to Fastener Notice.
Tighten the bolts to 30 N.m (22 lb ft).
