STS RWD V8-4.6L VIN A (2006)
Stabilizer Bushing: Service and Repair
Front
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tires and wheels.
3. Remove stabilizer shaft link to stabilizer shaft retaining nut.
4. Separate the stabilizer shaft link from the stabilizer shaft.
5. Remove the stabilizer shaft bracket mounting bolts.
6. Remove the stabilizer shaft bracket.
7. Remove the stabilizer shaft insulator.
Installation Procedure
1. Install the stabilizer shaft insulator to the stabilizer shaft with the slit facing rearward.
2. Install the stabilizer shaft bracket.
3. Install the stabilizer shaft bracket mounting bolts.
Tighten the bolts to 110 Nm (81 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.