STS RWD V8-4.6L VIN A (2006)
^
Tighten the front bolts to 265 Nm (195 ft. lbs.).
^
Tighten the rear bolts to 191 Nm (140 ft. lbs.).
4. Remove the jack from the vehicle.
5. Install a suitable jack under the lower control arm.
6. Using the jack raise the lower control arm until the shock absorber aligns with the knuckle.
7. Install the shock absorber lower retaining bolt.
Tighten the bolt to 150 Nm (111 ft. lbs.).
8. Remove the jack from the vehicle.
9. Connect the head lamp adjustment link to the upper control arm.
10. Connect the automatic level control sensor link to the upper control arm.
11. Install the tire and wheel.
12. Lower the vehicle.
Coil Spring Insulators Replacement
Coil Spring Insulators Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear coil spring.
3. Remove the upper coil spring insulator.
