STS RWD V8-4.6L VIN A (2006)
3. Install the shock absorber retaining nut.
Tighten the nut to 25 Nm (18 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the magnaride sensor nut.
5. Remove the shock module from the spring compressor.
6. Install the shock module to the vehicle.
7. Install the tire and wheel.
8. Lower the vehicle.
Shock Module Yoke Replacement
Shock Module Yoke Replacement
Tools Required
^
J24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the shock to yoke retaining nut.
4. Remove the shock to yoke retaining bolt by pulling up slightly on the lower control arm to remove the pressure on the bolt.
