STS RWD V8-4.6L VIN A (2006)
Install the input speed sensor bolt (2).
Tighten the input speed sensor bolt to 11 Nm (97 inch lbs.).
3. Connect the electrical wiring harness connector (1) to the input speed sensor (2).
4. Install the transmission fluid pan and filter.
Output Speed Sensor Replacement
Output Speed Sensor Replacement
Removal Procedure
1. Remove the transmission fluid pan and filter.
2. Disconnect the electrical wiring harness connector (3) from the output speed sensor (2).
3. Remove the output speed sensor bolt (3).
4. Remove the output speed sensor (2).
5. Remove the output speed sensor spacer (1).
6. Inspect the output speed sensor (2) for the following conditions:
^
Damaged or missing magnet
^
Damaged housing
^
Bent or missing electrical terminals
Installation Procedure
