STS RWD V8-4.6L VIN A (2006)
6. Install the control valve body accumulator assembly to the transmission case bolts (1-3) and hand tighten.
7. Important: If the bolts are tightened at random, valve bores may become distorted and inhibit proper valve operation.
Notice: Refer to Fastener Notice in Service Precautions.
Tighten the control valve body assembly bolts in sequence.
Tighten the bolts to 11 Nm (97 inch lbs.).
8. Install a 0.8 mm spacer (2) between the manual shaft detent lever (1) and the manual shaft detent spring (3).
9. Tighten the detent spring bolts.
Tighten the bolts to 11 Nm (97 inch lbs.).
10. Remove the spacer (2).
