STS RWD V8-4.6L VIN A (2006)
12. Install the propeller shaft CV joint to transfer case flange bolts.
Tighten the propeller shaft CV joint to transfer case flange bolts in sequence (1-6) to 30 Nm (22 ft. lbs.).
13. Install the center support bearing to the vehicle underbody.
14. Raise the support device in order to hold the support bearing in position.
15. Install the center support bearing bolts (2) to the studs on the vehicle underbody.
Tighten the support bearing bolts to 50 Nm (37 ft. lbs.).
16. Install the heat shield bolts to the mounting studs on the underbody.
Tighten the heat shield mounting bolts to 8 Nm (71 inch lbs.).
17. Remove the support device from the propeller shaft.
18. Install the exhaust system.
19. Lower the vehicle.
