STS RWD V8-4.6L VIN A (2006)
16. Position the large seal retaining clamp (1) onto the seal (2).
17. Position the seal and large retaining clamp to the joint outer race (3) as shown.
18. Position the joint assembly to the proper vehicle dimension.
19. Measure the distance (1) between the seal edges.
86.85 mm (3.42 inch).
20. Inspect the seal for proper shape. If the seal is not shaped correctly, equalize the pressure in the seal by lifting the seal edge slightly and shape the
seal properly by hand.
Important: The seal must not be dimpled, stretched or otherwise deformed.
21. Inspect the seal for damage. If the seal has been cut or punctured during assembly, you must discard and replace the seal.
22. Using the J42572, crimp the large seal retaining clamp.
Tighten the large seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 inch).
Important: The seal retaining clamp must not be over-tightened or under-tightened.
23. Inspect the inner joint for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the inner joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
3. Install the wheel drive shaft.
