STS RWD V8-4.6L VIN A (2006)
7. Install the New narrow retaining ring to the outer narrow ring groove (2) at the end of the wheel drive shaft.
8. Install the New wide spacer ring to the wide ring groove of the wheel drive shaft (1).
9. Position the outer joint horizontally.
10. Engage the inner race splines onto the axle shaft splines.
11. Compress the axle shaft ring spacer.
1. Press the end of the retaining ring, using a flat-bladed tool, into the axle shaft groove while firmly pressing the inner joint onto the axle shaft.
2. Continue to work around the retaining ring, until it is compressed.
12. Install the outer joint to the axle shaft.
Important: The axle shaft and inner race must be fully seated to each other.
1. Position a wood block over the end of the outer joint threaded shaft.
2. Use a hammer to drive the outer joint onto the shaft.
3. Continue to drive the outer joint until the inner joint seats fully onto the axle shaft.
