STS RWD V8-4.6L VIN A (2006)
14. Position the small seal retaining clamp (2) onto the neck of the seal (1).
15. Position the seal and small retaining clamp to the axle shaft (3) as shown.
16. Using the J42572 (1), crimp the small seal retaining clamp.
Tighten the small seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 inch).
The clamping hold time must be no less than 2 seconds.
Notice: Refer to Fastener Notice in Service Precautions.
Important: The seal retaining clamp must not be over-tightened or under-tightened.
