STS RWD V8-4.6L VIN A (2006)
20. Inspect the seal for proper shape. If the seal is not shaped correctly, equalize the pressure in the seal by lifting the seal edge slightly and shape the
seal properly by hand.
Important: The seal must not be dimpled, stretched or otherwise deformed.
21. Inspect the seal for damage. If the seal has been cut or punctured during assembly, you must discard and replace the seal.
22. Using the J42572 (1), crimp the large seal retaining clamp.
Tighten the large seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 inch).
Important: The seal retaining clamp must not be over-tightened or under-tightened.
23. Inspect the inner joint for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the inner joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
3. Install the wheel drive shaft.
Wheel Drive Shaft Inner Joint and Seal Replacement - Rear (AWD)
Wheel Drive Shaft Inner Joint and Seal Replacement - Rear (AWD)
Tools Required
^
J42572 Drive Shaft Seal Clamp Pliers
Disassembly Procedure
This procedure is to be performed only after the wheel drive shaft has been removed from the vehicle.
1. Wrap a shop towel around the axle shaft.
2. Place the wheel drive shaft horizontally in a bench vise.
3. Using a side cutter or other suitable tool, remove the large seal retaining clamp from the inner joint seal and discard the clamp.
4. Using a side cutter or other suitable tool, remove the small seal retaining clamp from the inner joint seal and discard the clamp.
5. Separate the seal from the inner joint outer race at the large diameter end.
6. Slide the seal away from the joint face.
7. Wipe the grease from the face of the joint inner race, cage, balls, etc.
