STS RWD V8-4.6L VIN A (2006)
3. Install the ABS electrical connector to the splash shield.
4. Connect the ABS electrical connector.
5. Install a new wheel driveshaft retaining nut.
Tighten the nut to 160 Nm (118 ft. lbs.).
6. Install the brake rotor.
7. Install the tire and wheel.
8. Lower the vehicle.
Wheel Bearing/Hub Replacement - Front (RWD)
Wheel Bearing/Hub Replacement - Front (RWD)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor.