STS RWD V8-4.6L VIN A (2006)
Important: Keep the cutting edge of the tool against the window.
8. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
9. With the aid of an assistant, use the suction cups in order to lift the rear window (2) from the opening.
Installation Procedure
1. The locator pins (1) are used in order to hold the rear window in position.
2. Install the rear window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows (See: Service and Repair) .
3. Connect all of the rear window electrical connectors.
4. Install the headliner. Refer to Headliner Replacement (See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair) in Interior
Trim.
5. Install the rear sail trim panels. Refer to Sail Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Removal and Replacement) in Interior Trim.