XLR V8-4.6L VIN A (2006)
1. Place the folding top in the down position.
2. Measure the gaps on both sides of the rear compartment lid. Determine the direction and amount of adjustment required. Refer to Folding Top
Clearance Gap Specifications.
3. Open the rear compartment.
4. Place a protective covering over the interior and the adjacent body panels.
5. Loosen the cross car bumper nuts (1) on the rear compartment lid.
6. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
Notice: Refer to Fastener Notice in Service Precautions.
7. Adjust the bumpers as necessary.
Tighten the nuts to 11 N.m (97 lb in).
8. Close the rear compartment.
9. Verify that the lid is aligned properly. Refer to Folding Top Clearance Gap Specifications.
10. Repeat the adjustment procedure as necessary.
11. Remove the protective covering.
12. Inspect the folding top for proper operation.
Cross Car Adjustment Procedure - Second Design
