XLR V8-4.6L VIN A (2006)
1. The windows will express open (if closed).
2. The front tonneau (three piece closure behind the seats) opens. The header latch unlatches. This latch is located in the middle forward area of the roof
panel. The deck lid/trunk lid opens.
Tip
If the top operation will not advance past Step 2, it is possible that:
^
The FTC module is not reading the Front Tonneau Position Sensor value at or above the Front Tonneau Open Reference Position Value.
^
The FTC module is not reading the Header Latch Limit Switches as Unlatched.
^
The FTC module is not reading the Deck Lid Ajar Status and Deck Lid Latch Switch as Deck Opened.
^
The FTC module is not reading the Deck Lid Extended as Active.
3. The top opens (roof retracts into the trunk).
Tip
If the top will not advance past Step 3, it is possible that the FTC module is not reading the Folding Top Position Sensor value at or below the Folding
Top Open Reference Position value.
4. The rear tonneau (the retracted panel below the deck lid) extends.
Tip
If the top will not advance past Step 4, it is possible that the FTC module is not reading the Rear Tonneau Position Sensor value at or below the Rear
Tonneau Closed Reference Position value.
5. The front tonneau closes. The header latch latches, securing the roof panel with the structure behind the seats.
Tip
If the top operation will not advance past Step 5, it is possible that:
^
The FTC module is not reading the Front Tonneau Position Sensor value at or below the Front Tonneau Closed Reference Position value.
^
The FTC module is not reading the Header Latch Limit Switches as Latched.
6. The trunk lid closes. Sequence complete.
Sequence for Closing the Folding Top
Before any movement of the folding top toward the closed position is allowed, the following conditions must be met or top operation will be inhibited:
^
The cargo cover must be pulled or extended into position (Luggage Barrier Limit Switch Closed).
^
Verify that the hydraulic pump bypass valve at the motor is in the operating position by turning the valve clockwise.
^
The valet switch is off/inactive, it is located inside the instrument panel compartment on the left side of the compartment.
^
The power windows are normalized, refer to Reinitialization of the Power Windows.
^
The vehicle is in PARK.
^
The ignition is in ACCESSORY or RUN.
To cycle the top from the open position to the closed position, press the folding top control switch in the close direction and hold. The folding top status
changes to Closing and the following steps will then take place:
1. The windows will express open (if closed).
2. The front tonneau (three piece closure behind the seats) opens. The header latch unlatches. This latch is located in the middle forward area of the roof
