XLR V8-4.6L VIN A (2006)
7. Cut a piece of Sheet Molded Compound (SMC) or galvanized steel (1) to cover the hole in the floor with at least a 25 mm (1 in) overlap on all
sides.
8. Apply a 6 mm (1/4 in) bead of adhesive (2) GM P/N 89020330 (Canadian P/N 8902332) around the perimeter of the cover.
Important: Fuel system components lie under the floor of the rear compartment panel. Do not use rivets or screws to attach the cover to
the floor.
9. Position the cover over the hole in the floor (1) and press firmly into place.
Important: A leak proof seal is necessary so that exhaust and fuel fumes cannot enter the vehicle.
10. Smooth out the adhesive around the cover.
11. Verify that no skips or gaps occur in the adhesive.
12. Allow adhesive to cure according to adhesive manufacturer's recommendations.
13. Install all related panels and components.
14. Install the rear floor trim panel.
