XLR V8-4.6L VIN A (2006)
Axle Nut: All Technical Service Bulletins
Drivetrain - Rear Axle Nut Torquing Procedure
Bulletin No.: 05-04-95-001
Date: November 11, 2005
INFORMATION
Subject:
Rear Wheel Drive Shaft Nut Torque Specification Requirements and Information on Replacement Shafts For Service
Models:
2004-2006 Cadillac XLR
2005-2006 Chevrolet Corvette
Rear Wheel Drive Shaft Nut Torque Procedure
Note:
^
If service requires the removal and reinstallation of the rear wheel drive shaft retaining nut, it is CRITICAL to follow the torque procedure below.
Failure to follow the torque procedure may result in a inadequate torque specification.
^
If service requires removal and reinstallation of the rear wheel drive shafts, clean the inboard mating surface of the wheel bearing and the mating
surface of the axle shaft of any foreign material prior to assembly. Failure to properly clean the mating surface may result in an inadequate torque
specification.
1.
Insert a drift or punch into the brake rotor cooling fins and against the caliper to prevent the wheel hub and bearing from turning.
2.
Begin to install the drive shaft retaining nut onto the drive shaft by hand.
3.
Slowly tighten the nut to draw the drive shaft to the wheel hub and bearing.
Tighten
Tighten the drive axle spindle nut to 160 N.m (118 lb ft).
4.
Remove the drift or punch.
Rear Wheel Drive Shaft Assembly Available for Service
Note:
^
If service requires the removal of the rear wheel drive half shaft retaining nut, it is CRITICAL to follow the torque procedure above.
Failure to follow the torque procedure may result in a inadequate torque specification.
^
If service requires the replacement of the rear wheel drive shafts, clean the inboard mating surface of the wheel bearing and the mating
surface of the axle shaft of any foreign material prior to assembly. Failure to properly clean the mating service may result in an inadequate
torque specification.
