Astro Van 2WD V6-4.3L VIN W (2001)
2. Install the extension to the instrument panel:
2.1.
Align the retainers.
2.2.
Press the extension into place until the retainers are seated.
3. Install the nuts that retain the extension to the floor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts that retain the extension to the floor to 8 Nm (71 lb in).
4. Install the retaining screws.
Tighten
Tighten the screws to 8 Nm (71 lb in).
5. Install the extension screw covers.
Air Outlet - Center Floor
AIR OUTLET REPLACEMENT - CENTER FLOOR
REMOVAL PROCEDURE
1. Remove the IP extension. Refer to "Instrument Panel (I/P) Extension".
2. Remove the floor air outlet duct from the air distributor.
3. Remove the bucket seats. Refer to "Seat Replacement - Bucket".
4. Remove the front section of the carpet, if equipped. Refer to "MAT/Carpet Replacement".