chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Power Steering - Whining Noise While Turning|Page 7107 > < Hydraulic Brake Booster Accumulator Replacement|Page 7098
Page 1
background image

Vacuum Brake Booster: Customer Interest
Power Steering - Whining Noise While Turning

File in section: 02 - Steering 

Bulletin No.: 02-02-32-005A

Date: April, 2002

TECHNICAL

Subject: 
Excessive Noise from Power Steering System While Turning or Under Light Braking (Replace Power Brake Booster Inlet Hose)

Models:
1999-2002 Chevrolet and GMC M/L-Van Models

This bulletin is being revised to change the model years. Please discard Corporate Bulletin Number 02-02-32-005 (Section 02 - Steering).

Condition

Some customers may comment on a whine noise coming from the power steering system while turning or braking.

Correction

Replace the power brake booster inlet hose, P/N 15094588. Follow the service procedure listed below.

1.

Remove the power brake booster inlet hose from the pump to the hydraulic booster and discard the hose. Refer to the Power Brake Booster Inlet
Hose Replacement procedure in the Service Manual (SI ID # 546584).

Important: 

Routing of the power brake booster inlet hose (1) at the hydraulic brake booster is critical for proper installation.

2.

Install and route the inlet brake booster hose (1) from the hydraulic brake booster to the rear of the outlet brake booster hose (2) and under the
brake lines (3) and down to the rear of the pump.

Tighten

Tighten the power brake booster inlet hose fittings to 27 N.m (20 lb ft).

3.

Bleed the power steering system. Refer to the Bleeding the Power Steering System procedure in the Service Manual (SI ID # 487449).

Parts Information

Parts are currently available from GMSPO.

Warranty Information

Power Steering - Whining Noise While Turning|Page 7107 > < Hydraulic Brake Booster Accumulator Replacement|Page 7098