Astro Van 2WD V6-4.3L VIN W (2001)
consists of 3 consecutive periods.
Battery Voltage: The scan tool displays the battery system voltage.
Content Theft Lamp: The scan tool displays the state of the SECURITY lamp. The scan tool displays ON when activated by an unauthorized entry.
Content Theft State: The scan tool displays the state of the content theft feature. The scan tool displays ON when activated by an unauthorized entry.
Door Key Switch: The scan tool displays the state of the door key switch. The scan tool displays ACTIVE when the switch is activated in either door
key cylinder.
Ignition 1: The scan tool displays the state of the ignition switch. The scan tool displays ACTIVE when the ignition switch is in the RUN or CRANK
position.
Ignition 3: The scan tool displays the state of the ignition switch. The scan tool displays ACTIVE when the ignition switch is in the RUN position.
Passlock(TM) Code: The scan tool displays the validity of the Passlock(TM) code received by the BCM. The scan tool displays OPEN, SHORTED,
TAMPER and a valid code as a numeric value (1-10).
Passlock(TM) Data Voltage: The scan tool displays the voltage code from the Passlock(TM) sensor to the BCM. The BCM determines if the voltage
received is a valid or invalid code voltage.
Passlock(TM) State: The scan tool displays the state of the Passlock(TM) system.
Security Lamp State: The scan tool displays the state of the SECURITY lamp. The scan tool displays ON, OFF or FLASHING.
Tamper Timer: The scan tool displays the time remaining when in the tamper mode. The timer starts when the ignition switch is turned to the RUN
position and the BCM receives a Passlock(TM) data voltage different from the last learned voltage. The timer has a delay of 10 minutes and will stay
active even if the ignition switch is cycled from the RUN to the OFF position.
PCM Fail Enable: The scan tool displays the state of the PCM fail enable mode. The scan tool displays YES when the Passlock(TM) system transitions
from the Monitor Passlock(TM) Data state to the PCM Fail Enable state.
PCM Fuel Continue: The scan tool displays the state of the PCM fuel continue mode. The scan tool displays YES when the Passlock(TM) system
verifies a valid password to the BCM.
PCM Learn Timer: The scan tool displays the state of the PCM learn timer. The scan tool displays INACTIVE when the BCM is not in a learn mode.
VTD Fuel Disable: The scan tool displays the state of the VTD fuel disable mode. The scan tool displays INACTIVE when the Passlock(TM) system
verifies a valid password.
VTD Fuel Disable Until Ignition Off: The scan tool displays the state of the VTD fuel disable until Ignition off mode. The scan tool displays NO when
the Passlock(TM) system verifies a valid password.
VTD Password Learn Mode: The scan tool displays the state of the VTD password learn mode. The scan tool displays INACTIVE when the
Passlock(TM) system is not in a learn mode.
