Astro Van 2WD V6-4.3L VIN W (2001)
Tighten the screws to 1.9 N.m (17 lb in).
7. Install the shim washer (1) or the bottom of the distributor shaft.
8. Install the tang washer.
9. Install the round washer.
10. Install the driven gear according to the index marks.
11. Align the rotor segment as shown for a V6 engine (1) or V8 engine (2).
12. Install the gear and align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
13. Check to see if the driven gear is installed incorrectly. On an incorrectly installed driven gear, the dimple will be approximately 180 degrees
opposite the rotor segment when the gear is installed in the distributor.
CAUTION: Refer to Safety Glasses Caution in Service Precautions.
