Astro Van 2WD V6-4.3L VIN W (2001)
2. Apply urethane adhesive into the reveal molding cavity and along the window edge.
3. Flush the windshield reveal molding cavity with low pressure lukewarm water.
This will help to shorten the urethane adhesive curing time.
4. Begin at the top of the window centerline and press the reveal molding into place.
5. Apply a second application of water on top of the molding.
6. Apply tape over the windshield reveal molding in order to keep the windshield reveal molding flush with the windshield while the adhesive cures.
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the screws that retain the right and left sides of the windshield frame filler panel.
Tighten the right and left sides of the windshield frame filler panel screws to 2 Nm (18 lb.in.).
