Astro Van 2WD V6-4.3L VIN X (2002)
Sliding Door Striker: Service and Repair
Striker Bolt Replacement - Sliding Door Front
Removal Procedure
1. Remove the shoulder belt guide bolt from the door pillar. Refer to Seat Belt Retractor Replacement - Right Rear .
2. Pull the trim panel forward and reach behind the trim panel to the striker bolt nut in order to remove the screw at the bottom of the door pillar trim.
3. Remove the striker bolt (4).
4. Remove the striker nut (1).
Installation Procedure
1. Install the striker nut to the inside of the door pillar.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the striker bolt (4).
Tighten the striker bolt to 67 N.m (49 lb ft).
3. Install the trim panel to the door pillar and the screw.
4. Install the shoulder belt guide bolt to the door pillar. Refer to Seat Belt Retractor Replacement - Right Rear .
