Astro Van 2WD V6-4.3L VIN X (2002)
Body Emblem: Service and Repair
Molding/Nameplate Replacement - Exterior Trim
Molding/Nameplate Replacement - Exterior Trim
Tools Required
J 41409 Body Molding Removal Tool
Removal Procedure
Remove the emblem or the molding:
1. Apply masking tape to the body side border of the emblem or the molding in order to protect the body from scratches. The tape will also aid in
aligning the moldings during installation.
2. Use J 41409 or a 0.8 mm (0.03 in) fishing line in order to cut through the adhesive material.
Installation Procedure
Important: Apply these items in an environment free of dust or dirt that could come in contact with the sticky backing and prevent
proper adhesion.
1. Clean the area where the molding or the emblem is to be mounted.
Use a suitable solvent, such as a mixture of 50 percent isopropyl alcohol and 50 percent water, or equivalent.
2. Dry the area thoroughly.
3. Ensure that the body area is at a temperature range of 27-41°C (80-105°F).
Heat the area, if needed.
4. Ensure that the emblems are at a temperature range of 29-32°C (85-90°F).
Place the emblem, adhesive side down, on a heated surface or use a heat lamp or a heat gun in order to raise the temperature.
5. Remove the protective liner on the back of the molding or the emblem.
6. Apply the molding or the emblem to the body surface.
7. Apply an equal amount of pressure along the molding or the emblem in order to uniformly bond the molding or the emblem to the body surface.
