Astro Van 2WD V6-4.3L VIN X (2002)
7. Only on the RWD, compress the outboard pad ears to the caliper.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the caliper mounting bolts.
^
Tighten the bolts to 51 Nm (38 ft. lbs.).
9. Only on the A4WD, remove the wheel lug nut securing the rotor to the hub.
10. Install the tire and wheel.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal approximately 2/3 of the pedal's travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Fill the brake master cylinder to the proper level.
16. Burnish the pads and rotors.