Astro Van 2WD V6-4.3L VIN X (2002)
18.
Connect the I/P module yellow 2-way connector located under the I/P extension.
19.
Install the CPA to the I/P module yellow 2-way connector located under the I/P extension.
20.
Connect the steering wheel module yellow 2-way connector located at the base of the steering column.
21.
Install the CPA to the steering wheel module yellow 2-way connector located at the base of the steering column.
22.
Position the knee bolster trim panel to the I/P and install the attaching screws.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
23.
Install the SIR fuse and install the fuse block cover.
24.
Be sure that the ignition is in the OFF position.
25.
Connect the negative battery.
Replacing the Multifunction Switch
This procedure describes how to replace ONLY the multifunction switch assembly. The new multifunction switch assembly will come complete
with a new hazard warning flasher switch already installed.
DO NOT use this procedure if the results of the inspection procedure indicate that only the hazard warning flasher switch requires replacement.
Contained in this procedure are unique steps to address features or options such as cruise control, standard or tilt column, and a column-mounted
automatic transmission lever.
Tools Required
^
J 1859-A Steering Wheel Puller
1.
Turn the ignition switch to the OFF position.
2.
Disconnect the negative battery.
3.
Remove the SIR fuse from the fuse block.
4.
Remove the screws attaching the driver's side knee bolster trim panel underneath the I/P and reposition the panel out of the way.
5.
Locate the driver's side yellow 2-way air bag electrical connector at the base of the steering column and remove the connector position assurance
(CPA) from the connector.
6.
Disconnect the yellow 2-way electrical connector.
7.
If equipped, remove the tilt steering column lever.
Important:
Some of the illustrations included in this procedure show the steering column removed from the vehicle. Those illustrations are for reference
