Astro Van 2WD V6-4.3L VIN X (2002)
27.
Remove the upper steering column trim cover mounting screws (1).
28.
Lift the upper steering column trim cover to gain access to the lock cylinder access hole.
29.
Using a bent tip awl, insert the tip into the ignition lock cylinder access hole.
30.
Turn the ignition lock cylinder to the START position.
31.
Using the bent tip awl, push down on the ignition lock cylinder retaining pin.
32.
Release the ignition lock cylinder to the RUN position.
33.
Remove the ignition lock cylinder from the lock module by pulling the ignition lock cylinder away from the steering column.
34.
Remove the upper column cover.
Important:
The illustration above is for the purpose of identifying the barcode only. The actual location of the barcode on the switch may differ.
